Watson-Marlow SP40 - Manual (Page 22)

INSTALLATION
19
5 INSTALLATION
5.1 Unpacking
When unpacking carefully follow the instructions as
given on the packaging or on the hose pump. Dispose
of the package material through the appropriate
channels.
5.2 Inspections
Check that your delivery is correct and check it for any
transport damage, refer to section 4.1. Report any
damage immediately to your Bredel representative.
5.3 Installation conditions
5.3.1 Ambient conditions
Make sure that the hose pump is in an area where the
ambient temperature during operation is not lower than
-20°C (-4°F) and not higher than +45°C (113°F).
5.3.2 Set-up
•
The pump materials and protective layers are
suitable for indoor set-up and a protected
outdoor set-up. Under certain conditions the
pump is suitable for limited outdoor set-up or a
salty or aggressive atmosphere. Consult your
Bredel representative for more information.
•
Make sure that the floor surface is horizontal
and has a maximum slope of 10 mm per meter.
Use suitable anchor bolts to attach the pump to
the floor surface.
•
Make sure that there is sufficient room around
the pump to carry out the necessary
maintenance activities.