Verilink PRISM 4101 (34-00230) Product Manual - Manual (Page 17)

2
I
NSTALLATION
This chapter describes each of the front panel LEDs and buttons as well as the
communication ports and power supply on the rear of the unit.
Unpacking and
Inspection Upon receipt of your shipment, inspect the shipping container and contents. If the
contents of the shipment are incomplete or, if there is mechanical damage or
defect, notify TxPORT Customer Service. If the shipping container or cushioning
material is damaged, notify the carrier and TxPORT immediately and make a
notation on the delivery receipt that the container was damaged (if possible, obtain
the signature and name of the person making delivery). Retain the packaging
material until the contents of the shipment have been checked for completeness
and the instrument has been checked both mechanically and electrically.
Supplied
Materials Your base shipment contains a PRISM 4101 unit with captive power supply
(F-4101-001--1111), an 8-pin to 8-pin modular network cable (9-1544-619-009), a
reference manual (34-00230), and configuration guide (45-00137).
Port
Connections On the rear of the unit, there are seven port connections as shown in Figure 2-1:
LAN, SLIP, SUPV, DBU, DDS, RS232 and V.35.
LAN The unit has an 8-pin modular jack labeled LAN. It can be equipped with either an
internal Ethernet or Token Ring network interface card (NIC) for connection to a
local area network (LAN) without changing the rear panel. This port functions
only when the optional NIC is installed. If the NIC is not installed, use the SLIP
port connection (page 6).
You can perform network management through the LAN port as well as the SUPV
port (page 7) or the SLIP port (page 6). The unit incorporates the full TCP/IP
stack, supports in-bound telnet, and has an embedded SNMP agent for trap
reporting or SNMP monitoring and management supporting the DDS specific and
TxPORT enterprise MIBs as listed in Appendix A.
LAN SLIP SUPV DBU DDS
115 VAC
60 HZ
RS232
V.35
Figure 2-1 PRISM 4101 Rear Panel