Verilink M1-3 (880-503136-001) Product Manual - Manual (Page 31)

Verilink M1-3 User Manual 3-1
Chapter
3
M1-3 Configuration Options
The M1-3 menu options provide module access for the following
tasks:
• Node and circuit configuration
• Activating and deactivating the node and circuit
• Setting alarms
NOTE: The options shown in this chapter depict options displayed
through the SCM Craft interface.
M1-3 Management
The M1-3 module is designed to operate with an SCM module. The
SCM Main Menu displays the contents of the shelf slots in a
selected node. In the SCM Main Menu:
• An “M” at the intersection of rows and columns designates the
shelf/slot location of an M1-3 module.
• The letter “S” displays where SCM modules are located.
• The letter surrounded by brackets
[ ]
designates the location
of the currently active module that can be referenced and
modified via submenus of the SCM Main Menu.
• On initial log in, the brackets surround the module used as the
log-in access point (for example, the SCM).
• The SCM Main Menu, option SSSS (shelf/slot) is used to move to a
desired module in the node.
In Figure 3-1 , the SCM Main Menu shows an M1-3 (designated by
“M”) in slot 6. From the shelf/slot command, the currently accessed
module indicated by the square brackets
[ ]
has been changed to
the M1-3 in slot 1.
The asterisk next to the “*S” indicates which SCM module is the
node master. The “A” at the beginning of the prompt indicates the
SCM you are accessing is the active SCM master.