Verilink M1-3 (880-503136-001) Product Manual - Manual (Page 16)

M1-3 Overview
1-6 Verilink M1-3 User Manual
Installation
The Verilink M1-3 application module is installed after the rear
connector module. For detailed installation procedures, refer to
Chapter 3 of
the AS3000: The Basics manual.
WARNING
Do not install the M1-3 with non-AS3000 equipment. Improper installation
can cause equipment damage.
M1-3 Specifications
The following specifications apply to the M1-3 application module
in the AS3000 environment.
Table 1-1 Network Specifications
Regulatory
Requirements
This product complies with the following regulatory specifications
as they apply to telecommunications equipment:
• FCC—Part 15, Subpart J, Class A: Computing devices
• 15.810: Radiated Emission
• 15.812: Conducted Emission
• UL 1459, 2nd Edition
• CSA—C225
Network Interface
Type DS3
Line Rate 44.736 Mbit/s ± 20 ppm
Framing C-bit parity, M13
Line Code B8ZS
Input Signal -11.7 dbm to +6.2 dbm, level DS3
Output Signal -4.7 dbm to +3.6 dbm (DSX-3 cross-connect point)
Impedance 75 Ω ± 5%
Connector BNC female, one each for TX and RX
Internal T1 Rate n × 1.544 Mbit/s, where n = 1 to 28
System Timing External T3 (BNC), Network, or Internal