M1-3 to quad t1 -8 – Verilink M1-3 (880-503136-001) Product Manual User Manual

Page 26

Quick Set-Up

2-8

Verilink M1-3 User Manual

M1-3 to QUAD T1

To map the M1-3, T1 number 17 to the QUAD T1, net port 1, do the
following:

1. Start from the Circuit Build Manager menu, type “A” (Add

Circuit).

Figure 2-8 Add Circuit Menu

2. From the Add Circuit Menu type “N”.

Type a name for the M1-3 to QUAD T1 circuit (for example
“m13_17_quadt1_1”).

3. Type “M”. Type “1” (only 64k mode is supported) .

4. Type “SP” (source port). Enter the shelf number, a comma, and

the slot number of the M1-3 (1,6).

5. Type “DP” (destination port). Type the shelf number, a comma,

and the slot number for the QUAD T1 (1,3). Type “1” (net1).

6. Type “ST” (source T1). Choose T1 number 17.

7. From the Add Circuit Menu select option “SM” (source

mapping). Choose timeslots 1 through 24 (1-24).

8. Type “DM” (destination mapping). Choose all 24 timeslots (1-

24).

9. Type “S” to setup the circuit. A message appears

Successful

Circuit Build

Circuit Build, then displays the Edit Circuit Menu (

-- ADD CIRCUIT MENU [1,1] SCM Firmware 1.18 --

N) name: -- M) mode: --

SP) src port: [-,-] undefined DP) dst port: [-,-] undefined

SP) src port: [-,-] undefined DP) dst port: [-,-] undefined
--port rate selection-- --port rate selection--

--port rate selection-- --port rate selection--

--port rate selection-- --port rate selection--
( undefined port ) ( undefined port )

( undefined port ) ( undefined port )

( undefined port ) ( undefined port )
( undefined port ) ( undefined port )

( undefined port ) ( undefined port )

( undefined port ) ( undefined port )
( undefined port ) ( undefined port )

( undefined port ) ( undefined port )

( undefined port ) ( undefined port )
( undefined port ) ( undefined port )

( undefined port ) ( undefined port )

bus: AUT ->-->>->> Circuit Inactive <<-<<--<-

S) setup X) exit

A [0.0.0.2] [1,1] SCM >