Triplett 9320-A User Manual

Page 35

Triplett Model 9320-A

Connect the test leads to the resistance to be measured.

Press the MAX / MIN button. The meter will memorize the MAXimum and MINimum
values read by the meter. When the MAX annunciator is visible in the LCD, the
MAXimum value is being displayed. When the MIN annunciator is visible in the
LCD, the MINimum value is being displayed. When viewing the MAX value, the
meter continues measuring and recording the MIN value, and when viewing the
MIN value, the meter continues to measure and record the MAX value. The user
can press the SELECT button to view one or the other.

To exit this mode, press and hold the MAX / MIN button until the meter beeps and
the MAX and MIN annunciators disappear. All memorized readings will be lost.
The meter will return to the normal measurement mode. The meter will be set to
the range it was in when the MAX / MIN mode was selected. It will not be in
Autoranging mode (the Auto annunciator will be off). To place the meter back
into Autoranging mode, press the SELECT button. Notice that this also changes
the mode setting (Ohms, Continuity, etc), so press the button repeatedly if needed
to obtain the desired setting.

9.9.4 Measuring Maximum and Minimum Temperature.

Attach the temperature probe and adaptor to the meter, paying attention to the
proper polarity. Rotate the FUNCTION switch to the

C /

F position. SELECT F or

C display as desired.

Make certain that the

annunciator on the display is not visible. If it is visible,

press the D-HOLD button to turn it off.

This manual is related to the following products:

9310-A