Warning – Triplett 9320-A User Manual

Page 27

Triplett Model 9320-A

9.3 Measuring Resistance

WARNING!!!

Do not apply voltage or current to the meter when it is set to

Refer to Section 7.0, Preparation For Use, and Section 8.0, General Measurement
Procedures, before attempting any measurements.

Select resistance measurements by rotating the Function Switch to the
position. When the FUNCTION switch is first selected to this position, the meter
will default to the Auto Resistance (

Ω

) mode.

Make certain that the

annunciator on the display is not visible. If it is visible,

press the D-HOLD button to turn it off.

Attach the test leads to the Tester. The red lead is connected to the V

Ω

Hz Jack,

and the black lead is connected to the COM Jack. With the leads open, the display
should display the Overrange OL indication. Short the leads together. The display
should indicate less than 000.5 Ohms.

Connect the leads to the circuit or component under test. See Figure 7.

FIGURE 7

RESISTANCE, DIODE, AND CAPACITANCE TESTS

This manual is related to the following products:

9310-A