Triplett 9007-A - Manual (Page 42)

42
9.1.3 Remove the 9 volt battery and, observing proper
polarity, replace with a fresh battery (PN 37-48).
9.1.4 Reassemble battery compartment cover.
Reinstall screws.
9.1.5 Verify that the meter operates properly before using
it to make measurements.
9.2 Replacing Fuses:
9.2.1 Remove the test leads from the meter.
9.2.2 Remove the 4 screws from the back of the meter
case. Flip up the Stand and remove 2 additional
screws. It is not necessary to remove the battery
cover screws.
9.2.3 Open the meter case by wiggling the back to
separate it from the front. Set the back of the case
to one side.
9.2.4 Locate the defective fuse and replace with the
exact or equivalent type. See meter
specifications.