Triplett 9007-A - Manual (Page 39)

39
7.11 TEMPERATURE MEASUREMENTS:
WARNING!
To avoid electric shock, disconnect both test probes from any source
of voltage before making a temperature measurement.
7.11.1 If you wish to measure temperature in
o
F, set the
function switch to the
o
F range. If you wish to measure
temperature in
o
C, set the
℉/℃ Button to the o
C range.
7.11.2 Insert the Temperature Probe into the negative (-) jack
(COM) and the positive (+) jack (Temperature),
indicated as
on the “Front Panel” drawing on page
22.
7.11.3 Touch the Temperature Probe head to the part whose
temperature you wish to measure. Keep the probe
touching the part under test until the reading stabilizes
(about 30 seconds).
7.11.4 Read the temperature in the display. The digital reading
will indicate the proper decimal point and value.
7.11.4 Do not connect the temperature probe to a voltage
source.
7.12 FREQUENCY MEASUREMENT:
7.12.1 Set the function switch to the 2000Hz position.