Tri Tool 765RVC Hyrdaulic Power Supply - Manual (Page 8)

8
TRI TOOL INC.
92-0306 : Rev. 140715
WARNING:
NOTE:
Model Designations
P/N with Kit No. Input Voltage
01-0765RVC
05-0146 480 VAC
05-0147 380 VAC
05-0148 240 VAC
Electrical Control Features
Magnetic starter with a 24 VAC starting coil and Overload Protection Circuit Breaker.
Phase sensor to prevent reverse rotation of the motor, which can damage the Hy-
draulic Pump.
The unit is controlled with a remote Pendant, which provides Stop/Start functions,
Variable Volume Control, and a Forward/Neutral/Reverse Control.
The Flow Direction Control is released in the neutral and forward position with
reverse not released and restricted to only supply 25% of the forward flow.
If the power supply has been shut-off with the Stop Button, the Variable Vol-
ume Control must be returned to the zero to start up.
The Pendant is supplied with a 20’ (6 m) cable that connects to the Control
Box.
The addition of extension cables will add up to 200’ (61 m).
Hydraulic Characteristics
Variable Volume 0 gpm (0 L/s) to 15 gpm (.94 L/s)
Operation below 3 gpm (.2 L/s) is not recommended.
The pump capacity is actually 0 gpm (0 L/s) to 22 gpm (10 L/s), however,
operating pressure must be limited to 1000 psi (6895 kPa) at flow over 15
gpm (.94 L/s) to avoid overloading the motor.