Thinklogical HDX80 Manual - Manual (Page 34)

Revision A December 2011 26
Step 3
Pull the Power Module out of the chassis.
Step 4
Insert the new Power Module into the chassis and slide it in until it reaches the backplane
connector. The module should slide freely until it reaches the backplane connector. At
this point, use just enough force to firmly engage the card with the mating connector.
Warning! If the module does not slide into the connector, do not force it!
Damage may occur. Remove the module and start over.
Part 2: Safety Requirements
Symbols found on the product
Markings and labels on the product follow industry-standard conventions. Regulatory markings
found on the products comply with requirements.
Regulatory Compliance
Thinklogical™ products are designed and made in the U.S.A. Products have been tested by a
nationally recognized testing laboratory and found to be compliant with the following standards
(both domestic USA and many international locations).
North America
These products comply with the following standards:
Safety
ANSI/UL60950-1: 1
st
Edition (2003)
CAN/CSA C22.2 No. 60950-1-03
LASER Safety
CDRH 21CFR 1040.10
Class 1 LASER Product
Electromagnetic Interference
FCC CFR47, Part 15, Class A
Industry Canada ICES-003 Issue 2, Revision 1