Thinklogical Router - ASCII-API - Manual (Page 32)

B) VEL-4 and VEL-24 through a VX160
Quick Start Guide:
VX160_VEL-4_VEL-24_Quick_Start_Rev_D.pdf
Number of fibers: TX24 - 3, L1, L2, L3 RX24 – 3, L1, L2, L3
TX4 - 2, L1, L2 RX4 – 2, L1, L2
Backchannel fiber: L2 (data flows from receiver to transmitter)
Tx24 fiber connections (green) Rx24 fiber connections (blue)
• L1 -> 20R L1 -> 20T
• L2 -> 20T L2 -> 20R
• L3 -> 19R L3 -> 19T
Tx4 fiber connections (green) Rx4 fiber connections (blue)
• L1 -> 4R L1 -> 1T
• L2 -> 4T L2 -> 1R
Commands (24 to 24, 4 to 4): (upper and lower case)
CI0020O0020 connects L1 video & data to RX24 (green to blue)
CI0019O0019 connects L3 video to RX24 (green to blue)
cI0020O0020 connects L2 data to TX24 (blue to green -
backchannel)
CI0004O0001 connects L1 video & data to RX4 (green to blue)
cI0001O0004 connects L2 RX4 data to TX4 (blue to green)
Now, let's connect the TX24 to the RX4:
dI0001 disconnects RX4 L2 (blue - backchannel)
CI0020O0001 connects TX24 L1 video & data to RX4 (green to
blue)
Note: RX4 L2 video is NOT connected. (blue - backchannel)
RX24 has full keyboard/mouse/USB/speaker access.
RX4 has sound (speakers) but no keyboard/mouse/USB.
To move the keyboard/mouse/USB from receiver 24 to receiver 4, issue the following commands:
dI0020 disconnects RX24 L2 data to TX (blue - backchannel)
dI0001 disconnects RX4 L2 data to TX (blue - backchannel)
cI0001O0020 connects RX4 L2 data to TX24 (blue to green -
backchannel) or
M;00200000000100000010020 Macro command that combines all three commands
The two ' dI' commands are sent to insure that the keyboard/mouse data only goes to a single transmitter. If you are certain
that there are no other K2 connections in place, you may eliminate them. Eliminating them will open the possibility of
sending keystrokes and/or mouse commands to multiple servers at the same time – a situation that will lead to disaster.
Jun 12, 2014 Router ASCII API: V4.5-1 31/33