Thinklogical Remote Power Distribution 12 Manual - Manual (Page 5)

P D U - 1 2 P r o d u c t M a n u a l ,
M a y , 2 0 1 4
Page 5
Note and Warning Symbols
Throughout this manual you will notice certain symbols that bring your attention to important
information. These are Notes and Warnings. Examples are shown below.
Note: Important Notes appear in blue text preceded by a yellow
exclamation point symbol, as shown here.
A note is meant to call the reader’s attention to helpful information at a point in the text that is
relevant to the subject being discussed.
Warning! All Warnings appear in red text, followed by blue text, and
preceded by a red stop sign, as shown here.
A warning is meant to call the reader’s attention to critical information at a point in the text
that is relevant to the subject being discussed.
1.0. Introduction
PDU-12 Power Distribution Unit (Part Number PDU-000012)
H: 1.72” (43.69 mm) x D: 10.52” (267.08mm) x W: 17.49” (444.29 mm)
1.1. Product Overview
The PDU-12 is a one rack-unit device that provides twelve +5 volt outputs via the rear panel.
Each unit contains two redundant, hot swappable AC-DC power supplies that are capable of
load sharing. These supplies plug into the rear of the chassis and have removable AC line
cords.
The rear panel features twelve DC Locking Power Jacks with a .100” diameter center pin.
Each +5 volt output is capable of sourcing +5 volts ±.25volts at a maximum of 4 amps.
PDU-12 Power Distribution Unit, rear panel