Tech Source Raptor OpenWindows for Solaris - Manual (Page 51)

Appendix A - Changing the Console Resolution
A-7
Use nvedit to remove the video-timing variable from
NVRAM using the following procedure:
1. Type nvedit at the ok prompt in Boot PROM mode.
2. Use to move to the next line until the cursor is on
the line where video-timing is defined.
3. Type to delete the line.
4. Type to exit the nvedit editor.
5. Type nvstore to save the changes.
6. Type setenv use-nvramrc? true to enable the
NVRAM.
7. Type reset-all to restart the system.
This procedure can also be used to remove the video-mode
variable if necessary.
See Appendix B for more information on nvedit commands.