Tech Source Raptor OpenWindows for Solaris - Manual (Page 45)

A-1
Appendix A
CHANGING THE CONSOLE
RESOLUTION
A.1 Overview
Normally the default console resolution is sufficient for most
users but if the monitor does not “sync-up” you may need to
change the console resolution.
The Raptor card can be configured to be the console in the
UltraSPARC workstation. Every Raptor card type has its own
default console resolution and default depth as shown in the
following table:
Board Resolution Refresh Bits/Pixels Sync
Raptor
1000 1280x1024 67Hz 8 Separate
Raptor
1100T 1280x1024 67Hz 8 Separate
Raptor
2000 2048x2048 60Hz 8 Separate
Raptor
2100T 2048x2048 60Hz 8 Separate
Raptor
2500 2560x2048 60Hz 8 Separate
Raptor
2500T
2560x2048 or
2048x2048
60Hz 8 Seperate
Raptor
2500T-DL
2560x2048 or
2048x2048
60Hz 8 Seperate
NOTE: It is recommended that you use raptorconfig to
test a resolution before configuring the console to that
resolution.