Tech Source Raptor OpenWindows for Solaris User Manual
Page 29

Chapter 4 – Software Installation for T-Class Cards
4-3
If /cdrom/cdrom0 does not exist, mount the CD-ROM
by typing the following:
prompt# mount -F hsfs -O -o ro \
/dev/dsk/c0t6d0s0 /cdrom
prompt# cd /cdrom/T-Class
6.
To install the software, type:
prompt# ./install_all
This script will ask you a number of yes-or-no questions
(generated by Sun's pkgadd installation program).
Answer these questions appropriately.
7.
If you did not install the MOX module and libraries in
Chapter 3, you can install them now by typing:
prompt# cd /cdrom/cdrom0/mox
or
prompt# cd /cdrom/mox
[if the CD-ROM was mounted as outlined in Step 5
above]
prompt# pkgadd –d . TSImox
Note: You must install the MOX package in order to use the
MOX extension.
8. Reboot the system to complete the installation.
One new device name is created in the /dev/fbs directory for
each Raptor card. It is denoted by rap1kt# for the Raptor
1100T, rap2kt# for the Raptor 2100T, and raptfp# for the
Raptor 2500T and Raptor 2500T-DL (where # represents an
instance number assigned by the operating system).