Tech Source Raptor OpenWindows for Solaris - Manual (Page 22)

Raptor OpenWindows for Solaris Installation and Reference Manual
3-6
‘t’
puts a test pattern on the entire
display (hit any key to return to
the main screen)
‘s’
saves current settings and exits
‘h’
help
‘q’ exits the program without saving
any changes
3.5 Setting Raptor as the Console
(Optional)
This section describes how to configure the Raptor as the
console device in your system. For information on setting the
resolution in console mode, please refer to Appendix A.
3.5.1 Raptor as the Only Framebuffer
3.5.1.1 Sun Blade 100 and Sun Blade 150
To use the Raptor as the system console on a Sun Blade 100 or
Sun Blade 150 use the following procedure:
1.
At the ok prompt, type: show-displays. This will list the
installed graphics devices and a prompt to enter a
selection.
NOTE: If the procedure for your system is not described
below, please contact Tech Source.