Tech Source Raptor OpenWindows for Solaris - Manual (Page 33)

Chapter 4 – Software Installation for T-Class Cards
4-7
‘h’
help
‘q’ exits the program without saving
any changes
4.6 Setting Raptor as the Console
(Optional)
This section describes how to configure the Raptor as the
console device in your system.
4.6.1 Raptor as the Only Framebuffer
4.6.1.1
Sun Blade 100 and Sun Blade 150
To use the Raptor as the system console on a Sun Blade 100 or
Sun Blade 150 use the following procedure:
1.
At the ok prompt, type: show-displays. This will list the
installed graphics devices and a prompt to enter a
selection.
2.
Type the letter that corresponds to the Raptor card that
you want to use as the console device. Raptor cards can
be identified by looking for the string TSI in the list of
device names.
3.
Type setenv output-device . When
you type , the display that was selected in
the previous step will be inserted in the command line.
NOTE: If the procedure for your system is not described
below, please contact Tech Source.