Teac CD-GT2 - Manual (Page 27)

IMPORTANT SAFETY INSTRUCTIONS
2 TASCAM CD-GT2
Listening to CDs
When the guitar cancel function is ON, the icon at the top
of the screen appears in inverse.
Depending on the music, the guitar cancel function may not
reduce the recorded guitar sound sufficiently. If this occurs,
changing the
PART
and
RANGE
settings might make the
reduction more effective. Listen to the music as you adjust the
settings to achieve the best effect.
NOTE
Depending on the recording of the music, reduction of
the guitar part with this function may not be possible.
PART
Adjust this setting to match the stereo position of the sound
that you want to reduce between
LEFT 10
and
RIGHT 10
.
The initial setting is
CENTER
.
RANGE
Select
MIDDLE
or
ALL
for the range of sound reduction. The
default setting is
MIDDLE
.
Loop playback
With this function you can continuously repeat the playback of
a selection that you make (loop playback).
1 Press the IN/OUT key during playback to set the point
when you want to start loop playback. The current
position is set as the IN point, and the symbol
appears below the playback position display bar at
that point.
2 Press the IN/OUT key at the point when you want loop
playback to stop. The current position is set as the
OUT point, and the symbol appears below the play-
back position display bar at that point. After setting
the OUT point, loop playback begins between the IN
and OUT points.
The play mode icon appears on the left of the display.
To stop loop playback, press either the LOOP key or the
IN/OUT key.
If you press the LOOP key, the loop interval settings are saved,
and if you press the LOOP key again loop playback of the set
interval begins again.
If you press the IN/OUT key, the loop interval settings (IN
point and OUT point settings) are canceled.