4 – preparation, Attaching the rackmount angles, Connecting the power – Teac US-16X08 Reference Manual User Manual
Page 10
10
TASCAM US-16x08
Attaching the rackmount angles
In order to mount this unit in a rack, you must remove the
frames and install the included rackmount angles. Follow these
procedures to change them.
(You will need a flat-bladed screwdriver.)
1. Use the hex key included with this product to remove the
four screws on each side from the positions shown below.
2. Remove the frames from both sides of the unit
3. Attach the included rackmount angles using the rackmount
angle attachment screws and the Phillips screwdriver that
you prepared.
4. Reverse these procedures to reinstall the frame pieces origi-
nally attached to the unit.
Connecting the power
Use the included AC adapter to connect a power supply to the
unit as shown below.
GPE248-120200-Z (included)
Power outlet
DC plug
In order to prevent the cord from becoming disconnected
during use, always wrap the cord around the cord holder when
connecting it.
CAUTION
• Always use the AC adapter (GPE248-120200-Z) that was
shipped with the unit. Using a different AC adapter could
cause malfunction, overheating, fire or other problems.
• The AC adapter for this unit includes two types of outlet
plugs. Attach the type of plug that matches the power outlet
that you are using.
8
Changing the outlet plug
$
%
2
1
5
3
4
1. Move the latch on the AC adapter in the direction of the
arrow.
2. Pull off the outlet plug.
3. Replace it with the other outlet plug (A or B).
4. Move the latch on the AC adapter in the direction of the
arrow again.
5. Attach the outlet plug to the AC adapter.
This completes changing the outlet plug.
After changing the outlet plug, confirm that it is not loose
or crooked and that everything is normal before plugging it
into an outlet.
CAUTION
Do not use the adapter if there is anything abnormal about
the plug after changing it. Use when the plug is abnormal
could cause fire or electric shock. Contact the retailer where
you purchased the unit or a TEAC service center (on the back
cover) to request repair.
4 – Preparation