Teac DM-24 Effects Manual - Manual (Page 20)

20
TASCAM DM-24 Effects
5 – TC Works Reverb
The TC Works reverberation built into the DM-24 is
a sophisticated reverb system, allowing you to simu-
late many different kinds of acoustic environment. Most common (and a few less common) parameters
can be edited, allowing fine control of the whole
sound.
NOTE
Due to technical limitations, if reverb is selected as one
effect, the reverb or speaker modeler cannot be
selected as the second effect.
It is also not available in high sampling frequency
mode.
General parameters
There are three general settings which are all set
using the top row of PODs. INTYPE stands for input type. There are four
options here: Stereo , L mono , R mono and LR mono .
The first three explain themselves, but the last refers
to a mono signal comprised of the L and R output
signals added together.
INPUT the input level can be adjusted from Off , and
then (in 5 dB steps) from –140 dB to –60 dB, (in
1 dB steps) from –60 dB to –20 dB and (in 0.1 dB
steps) from –20 dB to 0 dB.
OUTPUT The output level can be adjusted from Off ,
and then (in 5 dB steps) from –140 dB to –60 dB, (in
1 dB steps) from –60 dB to –20 dB and (in 0.1 dB
steps) from –20 dB to 0 dB.
MIX Adjust the wet/dry mix from 0% (dry) to 100%
only reverb) in 101 1% steps.
Balance controls
There are two balance controls on the second POD
row (
BALANCE ).
I/R This stands for “Initial Reflections” (sometimes
called Early Reflections”). POD 1 controls the left/
right balance of these reflections from 50 through 0 to
50 .
TAIL This stands for “reverb tail”—the final decay
of the reverb sound. POD 2 controls the left/right bal-
ance of these sounds from
50 through 0 to 50 .
Maximum decay time
HIGH MID LOW
Tail
Early
reflections
Initial
level
INLEV)
Pre-delay
(PREDLY) Reverb
feed
Reverb level
(REVLEV)
(REVFEED)