Teac TN-300 - Manual (Page 14)

14
Changing the cartridge
To change the cartridge, first remove the headshell from
the tone arm.
o We recommend that you keep the cartridge needle
protective cap on while changing the cartridge.
Headshell
Cartridge Shell leads
Screws
Nuts
1 Disconnect the shell lead terminals
from the cartridge.
2 Loosen the screws and remove the
cartridge.
3 Attach the new cartridge and tighten
the screws.
See the illustration below for the position of the
screws when attached.
2.0 ± 0.5 mm
4 Connect the shell lead terminals to the
cartridge.
o The signals and colors of the shell leads are
shown below.
Signal Color
Left channel + White
Left channel − Blue
Right channel + Red
Right channel − Green
5 Balance the tone arm and adjust the
stylus pressure.
Follow the procedures in “Balancing the tone arm
and adjusting the stylus pressure” on page 8.