Super Systems Paperless VR - Manual (Page 28)

Super Systems Inc. Page 27 Video Recorder Manual Version 2 Rev. B
Totalizers
This menu option will allow the user to add or
modify up to ten totalizers. If the totalizer selected
is already set up, then the user will be able to see
the type, the active inputs, and the date of the last
reset, which is where the totalizer is set back to
zero. If the totalizer is not already set up, the user
will only see the type and active inputs, which will be
blank. To select the type, click on the “Type” line
and then click the Edit button. The type can be one
of the following: Off, Seconds, Minutes, or Hours.
Select the desired type and click on the OK button to
set the type, or the Cancel button to cancel the
action.
To select the active inputs, click on the “Active
Inputs” line and then click on the Edit button.
This will display the screen where the user can
select the active inputs for the totalizer. To
select an input, the user can click on the desired
input, which will place a check mark next to the
input. The available inputs are Input 1 – Input 32.
After selecting the input(s), click on the OK
button to set the active inputs, or click on the
Cancel button to cancel the action.
Note: The
screen may take a few seconds to update the
active inputs and display them
. If the “Type” is
set to something other than Off, then the date of
the last reset will be displayed. If the “Type” is
changed from a value to Off, then the date of the
last reset will become invisible.
Note: The
totalizer will be reset every time a value is given for the type . The “RESET” line will allow the user to
force a reset for the totalizer. The user will have to confirm the reset first. To reset a totalizer, click on
the “RESET” line and then click on the Edit button. A message box will pop up confirming the reset. Click
on the Yes button to confirm and reset the totalizer, or click on the No or Cancel button to cancel the
action.
Averagers
Averagers allow the user to get an average value from
one or more inputs and display that average on the
graph.
Select the averager group to work with from the drop-
down list at the top of the screen. The options are:
Averager Group 1 – Averager Group 3. The first line,
“Enabled”, lets the user know if the selected averager
is enabled or not. Clicking on this line and then clicking
on the Edit button will allow the user to enable/disable
all three averager groups at once, instead of doing it