Super Systems Paperless VR - Manual (Page 12)

Super Systems Inc. Page 11 Video Recorder Manual Version 2 Rev. B
Each screen and Video Logging device is configured and setup with a fixed IP address. The screen is
configured to communicate with a specific device. This is done through the
Configuration  Target VR IP
Address Menu Option.
Change the IP Address of the Touch Screen
It is important to obtain an available IP address and correct Net Mask and Default Gateway from an
administrator or IT associate before changing any of the IP settings. In order to change the IP address of
the touch screen, the program must be shut down. Click on Start Menu
 Settings  Network and Dial-
up Connections. This will display the Network settings screen. Double-Click on the existing connection
to display the properties. To specify an IP address, select the “Specify an IP address” option and fill in the
sections for the IP Address, Subnet Mask, and Default Gateway using the on-screen keyboard, which can
be started by clicking on the Pen/Paper icon in the lower right corner and then clicking on “Keyboard”
from the menu option. Move the keyboard to a position where you will still be able to see the IP address
section and the keyboard at the same time. Highlight the first section of the IP address and enter the IP
address.
Note – The cursor will move to the next section once three digits have been entered . To enter a
two or one-digit section of the address, begin the section with zeroes, i.e., 001 instead of 1. Repeat for the
Subnet Mask and Default Gateway.
To have the IP address assigned by the network, select the “Obtain an IP address via DHCP” option. This
option will disable the text boxes for entering the IP address, since the IP address will be given by the
network. Click on the OK or X button on the top of the screen to close the screen.
Note – If the IP
address of the touch screen is changed, then the corresponding profile in the VR Manager will have to be
updated as well
.