Sundance SMT1026 User Manual

Page 48

Source code

The source code is similar for all the supported FPGA-only modules:

1- Open the FPGA library.

2- Reset the board and TIM.

3- Configure the FPGA.

4- Configure the ADCs/DACs.

5- Start the acquisition on the ADCs or trigger the DACs.

6- Save data to file (ADCs).

Tip: Change the value of the #define directives at the beginning of the program to
change the parameters. Don't forget to recompile!

5.3

Output

This folder contains the executable application.

It's installed in the following directory: "

C:/Program

Files/Sundance/SMT6026/Examples/SMT391/Output

Remark: SMT391 can be replaced by the number of the board you are interested in.