Sundance SMT1026 - Manual (Page 42)

1 - FPGA Configuration:
Bitstream: Select the FPGA bitstream. (This field is not used when the "Quick
Configuration" box is checked.)
Quick Configuration: Check this check box if the FPGA has already been configured with
the right bitstream. When this check box is checked, only a start key is sent to the FPGA
to reconfigure it.
Configure FPGA: Press this button to configure the FPGA of the SMT391.
2 - DAC Configuration:
Direct data / Memory data: Select the source of the input data.
Sampling Frequency: Set the sampling frequency for the DACs of the SMT381. The range
is from 50MHz to 500MHz.
Signal Frequency: Set the signal frequency of the signal to write to the DAC memories.
Signal selection: Select the type of signal to write to the DAC memories.
On board clock: Check this check box if you are using the on board clock.
Configure DAC: Press this button to configure the DACs of the SMT381.