Sundance SMT1026 - Manual (Page 45)

1 - FPGA Configuration:
Bitstream: Select the FPGA bitstream. (This field is not used when the "Quick
Configuration" box is checked.)
Quick Configuration: Check this check box if the FPGA has already been configured with
the right bitstream. When this check box is checked, only a start key is sent to the FPGA
to reconfigure it.
Configure FPGA: Press this button to configure the FPGA of the SMT391.
2 - ADC Configuration:
Sampling Frequency: Set the sampling frequency for the ADCs of the SMT391. The range
is from 50MHz to 1GHz.
Analog gain: Set the analog gain. The range is from 0 to 255.
Offset Compensation: Set the offset compensation. The range is from 0 to 255.
On board clock: Check this check box if you are using the on board clock.
DRDA channel I & Q: Set the DRDA value. This value depends of the FPGA module and
the sampling frequency.