Space Ray LTS Series Two Stage - Manual (Page 12)

Form #43155040
May 2013
-11-
8.3) LTU 180-250 SERIES HEATER ASSEMBLY OVERVIEW
Draft Inducer
Control Box
Aluminized Calorized Steel Tube (ALC)
(with two 12 radial hole Flanges)
U-Bend
Aluminized Calorized Steel Tube (ALC)
(with one 12 radial hole Flange)
10 FT. BODY PACKAGE
Part No. 42882020
15 FT. BODY PACKAGE
Part No. 42881000
Tube Support/
Hanger Bracket
Models: Models: Models: Models: LTU LTU LTU LTU 180 180 180 180----2 2 2 20 0 0 00 0 0 0
Alumi-Therm Calorized Steel Tube (ATC)
(with two 6-hole Flanges)
Draft Inducer
*Control Box
Aluminized Calorized Steel Tube (ALC)
(with two 12 radial hole Flanges)
*IMPORTANT
FOR MODELS LTU 225-250. THE CONTROL BOX MUST
BE ATTACHED TO AN ALUMI-THERM STEEL TUBE
HAVING 6-HOLE FLANGES.
10FT. BODY PACKAGE
Part No. 42882030
15 FT. BODY PACKAGE
Part No. 42881000
Models: Models: Models: Models: LTU LTU LTU LTU 225 225 225 225----2 2 2 25 5 5 50 0 0 0
8.4) LTU SERIES 15’ BODY PACKAGE OPENING
Follow the procedure below to open the 15’ body package.
1. Remove end reflectors from packaging.
2. Lift the tube at the flange end, then slide tube support/hanger bracket between marks on tubes and
tighten the “U” bolt hex nuts. Follow instructions in Sections 8.5) and 8.6) for the field assembly of the
heater.
92” reference
Remove end reflectors
from packaging.
Slide tube support/hanger bracket between
marks on tubes and tighten the “U” bolt
hex nuts.
1 2 Lift this end.
6”
reference
84” reference