Mart, Anel, Nstallation – SP Controls SmartPanel User Manual
Page 60: Installing the terminal blocks
Page 56
SmartPanel Configuration and Installation Guide
www.spcontrols.com
© 2002-8 SP Controls, Inc. 930 Linden Ave. So. San Francisco CA 94080
S
MART
P
ANEL
I
NSTALLATION
Installing the Terminal Blocks
CORRECT-
GOOD FOR FINAL
INSTALLATION
CORRECT-
GOOD FOR
TESTING
INCORRECT-
POLARITY COULD
BE REVERSED
Figure 26: Installing the phoenix connector terminal blocks
The included phoenix connector terminal blocks can be inserted onto their headers in three
different ways, two correct and one incorrect, as shown in Figure 26.
Note: We recommend using only the two leftmost methods shown in Figure 26. The rightmost
method allows terminal blocks to be inserted backwards, which can cause communications
failure and power to be inserted with the wrong polarity.
Note: Never pry under a terminal block with a screwdriver when removing it, as this may damage
the printed circuit board underneath.