Smithco Spray Star 1000 (sn 100199 – 100223) Parts & Service Manual - Manual (Page 109)

107
Accessories
10-105 FOAM MARKER PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 Control Box Bracket 1
2 HB-14-20-250 Bolt 1 /
4
- 20 x 2 1 /
2
1
HNTL-14-20 Lock Nut 1 /
4
- 20 1
3 10-198 Foamer Tank Bracket 1
4 16-939 Tank Strap 1
HB-516-18-200 Bolt 5 /
16
- 18 x 2 2
HNTL-516-18 Lock Nut 5 /
16
- 18 2
5 HB-38-16-125 Bolt 3 /
8
- 16 x 1 1 /
4
2
HW-38 Washer 3 /
8
2
HNTL-38-16 Lock Nut 3 /
8
- 16 2
6 10-127 Tank Mount 1
7 HB-38-16-225 Bolt 3 /
8
- 16 x 2 1 /
4
2
HNTL-38-16 Lock Nut 3 /
8
- 16 2
8 10-213 Foamer Compressor Bracket 1
FOAM MARKER INSTALLATION
1. Before working on machine stop engine, set park brake, remove key from ignition and block wheels.
Disconnect negative (-) battery terminal.
2. To mount the control box on the right side tube, you need to drill a 9 /
32
hole in the center of the tube even
with the seat. Use a 1 /
4
- 20 x 2 1 /
4
bolt and lock nut to bolt the bracket (Ref 1) that comes with the control
box to the side panel.
3. Now mount the foamer compressor bracket (Ref 8) to the horizontal boom support. Use two 3 /
8
- 16 x 2 1 /
4
bolts and lock nuts.
4. Remove the original mounting bracket from the compressor, saving the hardware, and mount the com-
pressor on the bracket you just put on the boom support. Use existing hardware.
5. Use the extension wire (10-222) to connect the compressor to the control box.
6. Between the gas tank and the machine there are extra holes in the gas tank mount (Ref 6). Place the
foamer tank bracket (Ref 3) on top of the gas tank mount and bolt down with 3 /
8
- 16 x 1 1 /
4
bolts, washers,
and lock nuts.
7. Place the foamer tank (21-464) on the foamer tank bracket (Ref# 3) and hold in place with the tank strap
(Ref 4) using two 5 /
16
- 18 x 2 bolts and lock nuts.
(Continued On Next Page)