Smithco Spray Star 1000 (sn 100199 – 100223) Parts & Service Manual - Manual (Page 103)

101
Accessories
HOSE REEL MOUNT PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 HB-38-16-375 Bolt 3 /
8
- 16 x 3 3 /
4
4
HNTL-38-16 Lock Nut 3 /
8
- 16 4
2 10-205 Boom Carrier (part of machine) 2
3 10-221 Hose Reel Mount 1
4 16-906 Electric Hose Reel 1
16-129 Manual Hose Reel 1
5 18-249 Barb Fitting 3 /
4
MPT x 3 /
4
HB 1
6 HB-516-18-150 Bolt 5 /
16
- 18 x 1 1 /
2
4
HNTL-516-18 Lock Nut 5 /
16
- 18 4
HOSE REEL MOUNTING INSTRUCTIONS
1. Wear protective clothing when draining the tank and taking apart the lines.
2. Drain tank and spray system in a safe and approved method insuring that no chemical or water remain in
tank as you will be taking apart lines.
3. Remove key from ignition, set park brake and block wheels.
4. Remove square rubber covers on boom carriers. Cut a notch into the covers to clear the top bolt then put
them back in.
5. Place hose reel bracket inside the boom carrier tubes with arms pointing toward front of machine.
6. Lower bracket until top hole in bracket lines up with hole in upright. Use four 3 /
8
- 16 x 3 3 /
4
bolts and four 3 /
8
- 16 lock nuts with nuts on inside of uprights.
7. Put hose reel on hose reel bracket with fitting on left side of machine. Use four bolts 5 /
16
- 18 x 1 1 /
2
and four
5 /
16
- 18 lock nuts to hold in place. Tighten bolts.
8. Put 18-249 barb fitting into hose reel.
9. For 1006 & 1002 System: Remove pressure regulating valve from manifold ball valve . Use a 1" close
nipple on each side of the tee. Place reducer bushing , 3 /
4
close nipple, ball valve, and hose barb into tee
pointing upward.
10. For 1004 System: From the back of the machine remove the two elbows at the end of the spray fittings.
Insert the 3 /
4
" tee pointing toward the back of the machine. Insert the 3 /
4
" hose barb elbow into the top of
the tee. This goes to the right boom section. Place a 3 /
4
" close nipple into the open end of the tee and add
the 3 /
4
" FPT elbow pointing upward. Insert the 3 /
4
" reducer bushing, ball valve, and hose barb.
11. Use 8887-46 hose to connect reel to ball valve, clamp with 18-040 hose clamps.
12. Use 22-075 cable ties to tie hose to main feed hose.
(Continued on next page)