Skutch Electronics BA-1000-A V1.15 - Manual (Page 10)

Version 1.15 Page 10
After the message starts to play, enter:
*0506# *0506# *0506# *0506#
Wait 1 seconds.
Press:
5 5 5 5
For BEST audio quality, hold the microphone 3
inches away from your mouth; when tone stops,
immediately dictate your message.
Press the * * * * to end.
To exit, press * * * *.
Sample Outgoing Message
"ABC Productions! I'm sorry but we are not
available to answer your call at this time. If you
need immediate assistance, please leave your
message then dial
8 8 8 8 on your telephone and we
will return your call very shortly. Thank you."
Remote Group
Number
Programming
Call the BA-1000-A from a Touch Tone
telephone.
After the message starts to play, enter:
*0506# *0506# *0506# *0506#
Wait 1 second.
Press:
8 8 8 8
Enter the new Group number.
To exit, press
* * * *.
Remote Change
Between Idle &
Answer Modes
Call the BA-1000-A from a Touch Tone
telephone. If the system is in Idle Mode, it will ring
10 times before answering.
After the message starts to play, enter:
*0506# *0506# *0506# *0506#
Wait 1 second.
Press:
0 0 0 0 to change the state; first press
“Enables” (changes to Answer Mode), next press
“Disables” (changes to Idle Mode).
To exit, press * * * *.
Support
! Audio Quality Problems
If the audio quality of your outgoing messages
is poor, try the following:
" Hold the microphone so the head is at
about chin level, approximately 3 inches
from your chin.
" Speak your message in a loud clear voice.
" The audio quality through the speaker
will never be as good as through the
phone line; so have the system call some
other phone you can listen to (make sure
the volume on the system is all the way
down).
! CODEC Initialize Error
When the system initially powers up, it must set
up the phone line and local audio circuits. During
this process, the following conditions may appear.
CODEC 2 error
If the following message appears:
CODEC Initialize
Error--> CODEC 2
Most likely the microphone is plugged into the
system. The microphone MUST be unplugged
whenever you are NOT recording, otherwise the
system will, on power failure, lock up on this
message. You can only correct this problem by
removing the microphone, unplugging power, then
reconnect power.