Fig #2, Align to this edge – Skutch Electronics CK-1P6 User Manual
Page 2
Page 2 of 4
Align to this edge
Center White Lines with Label
Fig #2
5- Make sure that the surface area of the base phone, where the sensor board is to be
mounted, is clean and free of all dust and oil film. Peel off the paper protector from the
bottom of the sensor board, and carefully place it OVER the LINE 1 and LINE 2 buttons
on the Panasonic Corded phone as shown in Fig. 2. Make sure that you align the Sensor
Board to the Black Edge of the phone as shown. Also make sure that the two white
stripes on the left side of the sensor board are centered with the "2 LINE" Label. See Fig
#2.
6- Connect the POWER CUBE from the CK-1 Black Box to 115VAC power. That's it!
LINE 1/2
Fig #1
Connect to Wall Jack
Connect to Audio Player
LINE 2
- CK-4 (2 pages)
- CK-4 (2 pages)
- BA-22 (2 pages)
- AS-6 (3 pages)
- AS-55 (2 pages)
- AS-26 (2 pages)
- AS-4A (2 pages)
- AS-702 (2 pages)
- AS-702-B (2 pages)
- AS-703-M (2 pages)
- AS-703-SBC (2 pages)
- AS-801 (4 pages)
- AS-801 (6 pages)
- BA-5 (2 pages)
- BA-704-2 (2 pages)
- BA-704 (2 pages)
- CK-1A (5 pages)
- CK-1A3 (4 pages)
- CK-1A4 (4 pages)
- CK-1A4 (4 pages)
- CK-1P2 (5 pages)
- CK-1A6 (4 pages)
- CK-1A6 (4 pages)
- CK-1A7 (4 pages)
- CK-1P3 (4 pages)
- CK-1P4 (4 pages)
- CK-1P5 (4 pages)
- CK-1P5 (4 pages)
- CK-1P6 (4 pages)
- CK-1P7 (5 pages)
- CK-1P (5 pages)
- CK-1P8 (4 pages)
- CK-1P9 (4 pages)
- CK-1R2 (4 pages)
- CK-1R3 (4 pages)
- CK-1R3 (4 pages)
- CK-1R4 (4 pages)
- CK-2 (5 pages)
- CK-7 (2 pages)
- DL-11 V3.00 (2 pages)
- EX-12 (2 pages)
- DL-4 (7 pages)
- BA-1000 (5 pages)
- BA-1000 (6 pages)