See pictures on next page – Skutch Electronics CK1 User Manual
Page 2
will partially transfer to the phone. Now pull the sensor board away from the
telephone. See Pictures 4 , 5, and 6.
7.
The glue MUST air cure for at least 30 seconds before you re-attach it to
the phone. This is necessary so that the contact cement will get tacky and
will grab and hold properly when re-attached.
8. Carefully align the sensor board to the phone. CAUTION: Once you touch the sensor
board to the phone, it will be very difficult to move it. You MUST align the sensor
board correctly BEFORE touching it down on the phone! Once you are SURE that it is
aligned properly, press the sensor board down on the phone and allow it to stick.
That’s it!
See Pictures on Next Page!
See also other documents in the category Skutch Electronics Equipment:
- CK-4 (2 pages)
- CK-4 (2 pages)
- BA-22 (2 pages)
- AS-6 (3 pages)
- AS-55 (2 pages)
- AS-26 (2 pages)
- AS-4A (2 pages)
- AS-702 (2 pages)
- AS-702-B (2 pages)
- AS-703-M (2 pages)
- AS-703-SBC (2 pages)
- AS-801 (6 pages)
- AS-801 (4 pages)
- BA-5 (2 pages)
- BA-704-2 (2 pages)
- BA-704 (2 pages)
- CK-1A (5 pages)
- CK-1A3 (4 pages)
- CK-1A4 (4 pages)
- CK-1A4 (4 pages)
- CK-1P2 (5 pages)
- CK-1A6 (4 pages)
- CK-1A6 (4 pages)
- CK-1A7 (4 pages)
- CK-1P3 (4 pages)
- CK-1P4 (4 pages)
- CK-1P5 (4 pages)
- CK-1P5 (4 pages)
- CK-1P6 (4 pages)
- CK-1P6 (4 pages)
- CK-1P7 (5 pages)
- CK-1P (5 pages)
- CK-1P8 (4 pages)
- CK-1P9 (4 pages)
- CK-1R2 (4 pages)
- CK-1R3 (4 pages)
- CK-1R3 (4 pages)
- CK-1R4 (4 pages)
- CK-2 (5 pages)
- CK-7 (2 pages)
- DL-11 V3.00 (2 pages)
- EX-12 (2 pages)
- DL-4 (7 pages)
- BA-1000 V3.12 (16 pages)
- BA-1000 V5.xx (18 pages)