Fig #2 – Skutch Electronics CK-1P8 User Manual
Page 2
Page 2 of 4
the phone. Once you are SURE it is aligned correctly, press down firmly to adhere to
phone.
CAUTION: The SENSOR BOARD must be aligned correctly or the unit will not
operate. If you need to remove the SENSOR BOARD once it is attached, slowly lift up
on one edge of the SENSOR BOARD. Pulling the SENSOR BOARD off fast WILL
damage the foam pad.
FIG #2
Align to side edges of
shiny black panel on
phone.
Before
After
See also other documents in the category Skutch Electronics Equipment:
- CK-4 (2 pages)
- CK-4 (2 pages)
- BA-22 (2 pages)
- AS-6 (3 pages)
- AS-55 (2 pages)
- AS-26 (2 pages)
- AS-4A (2 pages)
- AS-702 (2 pages)
- AS-702-B (2 pages)
- AS-703-M (2 pages)
- AS-703-SBC (2 pages)
- AS-801 (4 pages)
- AS-801 (6 pages)
- BA-5 (2 pages)
- BA-704-2 (2 pages)
- BA-704 (2 pages)
- CK-1A (5 pages)
- CK-1A3 (4 pages)
- CK-1A4 (4 pages)
- CK-1A4 (4 pages)
- CK-1P2 (5 pages)
- CK-1A6 (4 pages)
- CK-1A6 (4 pages)
- CK-1A7 (4 pages)
- CK-1P3 (4 pages)
- CK-1P4 (4 pages)
- CK-1P5 (4 pages)
- CK-1P5 (4 pages)
- CK-1P6 (4 pages)
- CK-1P6 (4 pages)
- CK-1P7 (5 pages)
- CK-1P (5 pages)
- CK-1P9 (4 pages)
- CK-1R2 (4 pages)
- CK-1R3 (4 pages)
- CK-1R3 (4 pages)
- CK-1R4 (4 pages)
- CK-2 (5 pages)
- CK-7 (2 pages)
- DL-11 V3.00 (2 pages)
- EX-12 (2 pages)
- DL-4 (7 pages)
- BA-1000 V3.12 (16 pages)
- BA-1000 V5.xx (18 pages)