Fig #1, Fig #2 – Skutch Electronics CK-1P6 User Manual
Page 2
Page 2 of 4
5- Make sure that the surface area of the base phone, where the sensor board is to be
mounted, is clean and free of all dust and oil film. Peel off the paper protectors from the
bottom of the sensor board, and place it OVER the LINE 1 and LINE 2 buttons on the
Base phone as shown in Fig. 2. The Sensor fits the contour of the phone, and will almost
“click” into place. No
alignment should be needed.
The Sensor board MUST
completely cover the LINE
buttons on the phone.
6- Connect the POWER CUBE
from the CK-1 Black Box to
115VAC power. That's it!
LINE 2
LINE 1/2
Connect to Wall Jack
Connect to AudioPlayer
Fig #1
RCA
Center white
lines with
blue Label
Fig #2
See also other documents in the category Skutch Electronics Equipment:
- CK-4 (2 pages)
- CK-4 (2 pages)
- BA-22 (2 pages)
- AS-6 (3 pages)
- AS-55 (2 pages)
- AS-26 (2 pages)
- AS-4A (2 pages)
- AS-702 (2 pages)
- AS-702-B (2 pages)
- AS-703-M (2 pages)
- AS-703-SBC (2 pages)
- AS-801 (4 pages)
- AS-801 (6 pages)
- BA-5 (2 pages)
- BA-704-2 (2 pages)
- BA-704 (2 pages)
- CK-1A (5 pages)
- CK-1A3 (4 pages)
- CK-1A4 (4 pages)
- CK-1A4 (4 pages)
- CK-1P2 (5 pages)
- CK-1A6 (4 pages)
- CK-1A6 (4 pages)
- CK-1A7 (4 pages)
- CK-1P3 (4 pages)
- CK-1P4 (4 pages)
- CK-1P5 (4 pages)
- CK-1P5 (4 pages)
- CK-1P6 (4 pages)
- CK-1P7 (5 pages)
- CK-1P (5 pages)
- CK-1P8 (4 pages)
- CK-1P9 (4 pages)
- CK-1R2 (4 pages)
- CK-1R3 (4 pages)
- CK-1R3 (4 pages)
- CK-1R4 (4 pages)
- CK-2 (5 pages)
- CK-7 (2 pages)
- DL-11 V3.00 (2 pages)
- EX-12 (2 pages)
- DL-4 (7 pages)
- BA-1000 V3.12 (16 pages)
- BA-1000 V5.xx (18 pages)