Fig #2, Before after – Skutch Electronics CK-1A7 User Manual
Page 2
Page 2 of 4
easy. The SENSOR board completely covers the Line 1 and Line 2 push buttons on the
phone.
1- Make sure that the surface on the telephone is clean and free of dust and/or oil.
2- Peel the paper protectors off back side of the "SENSOR BOARD" . Carefully slide
SENSOR board snug against corner of phone as shown in Fig. 2. The Sensor Board
MUST completely cover the line selector buttons on the phone. Once you are SURE it is
aligned correctly, press down firmly to adhere to phone.
CAUTION: The SENSOR BOARD must be aligned correctly or the unit will not
operate. If you need to remove the SENSOR BOARD once it is attached, slowly lift up
on one edge of the SENSOR BOARD.
Before
After
SENSOR Board
fits contour of phone
FIG #2
See also other documents in the category Skutch Electronics Equipment:
- CK-4 (2 pages)
- CK-4 (2 pages)
- BA-22 (2 pages)
- AS-6 (3 pages)
- AS-55 (2 pages)
- AS-26 (2 pages)
- AS-4A (2 pages)
- AS-702 (2 pages)
- AS-702-B (2 pages)
- AS-703-M (2 pages)
- AS-703-SBC (2 pages)
- AS-801 (4 pages)
- AS-801 (6 pages)
- BA-5 (2 pages)
- BA-704-2 (2 pages)
- BA-704 (2 pages)
- CK-1A (5 pages)
- CK-1A3 (4 pages)
- CK-1A4 (4 pages)
- CK-1A4 (4 pages)
- CK-1P2 (5 pages)
- CK-1A6 (4 pages)
- CK-1A6 (4 pages)
- CK-1P3 (4 pages)
- CK-1P4 (4 pages)
- CK-1P5 (4 pages)
- CK-1P5 (4 pages)
- CK-1P6 (4 pages)
- CK-1P6 (4 pages)
- CK-1P7 (5 pages)
- CK-1P (5 pages)
- CK-1P8 (4 pages)
- CK-1P9 (4 pages)
- CK-1R2 (4 pages)
- CK-1R3 (4 pages)
- CK-1R3 (4 pages)
- CK-1R4 (4 pages)
- CK-2 (5 pages)
- CK-7 (2 pages)
- DL-11 V3.00 (2 pages)
- EX-12 (2 pages)
- DL-4 (7 pages)
- BA-1000 V3.12 (16 pages)
- BA-1000 V5.xx (18 pages)