Skutch Electronics CK-1A3 - Manual (Page 2)

Page 2 of 4
2- Set the phone on the CK-1A3 box as shown in Figure #2.
3- Connect the audio cord from your audio source, to the AUDIO IN jack on the back of
the CK-1 box. For DIGITAL units use the cable that comes with the player, not ours.
4- Connect a MOD cord from Telephone Wall Jack 1&2 to [1&2 Line on CK-1A3].
5- Peel off the protector papers from the bottom of the sensor board, and carefully place it
OVER the LINE buttons on the phone set as shown in Fig. #4 & Fig. #5. Center the
WHITE LINES on the sensor board, over the 1 & 2 buttons on the phone. The SENSOR
BOARD MUST be attached to the phone for proper operation.
Align Whit e Lines
on Sensor Board t o
cent er of But t ons
Fig. #4