Sierra Video RCP-1616 - Manual (Page 42)

SIERRA VIDEO
32
For example, to set the IP address to 192.168.1.251
 Press and hold the FUNC button until it turns BLUE.
 Press Output Button 26 on the Aspen RCP-3232 or Output Button 10 on the
Aspen RCP-1616. This button will turn blue.
 Press OUTPUT 1 button. After the current octet value displays,
• Press input 1
• Press input 9
• Press input 2. The Take button is now blinking.
• Press Take
 Press OUTPUT 2 button. After the current octet value displays,
• Press input 1
• Press input 6
• Press input 8. The Take button is now blinking.
• Press Take
 Press OUTPUT 3 button. After the current octet value displays,
• Press input 10
• Press input 10 again
• Press input 1. The Take button is now blinking.
• Press Take
 Press OUTPUT 4 button. After the current octet value displays,
• Press input 2
• Press input 5
• Press input 1. The Take button is now blinking.
• Press Take
Reset the IP address only to Factory Default
To reset IP address, subnet and gateway of the RCP without changing any other of the
settings or conditions:
 Press and hold the FUNC button until it turns BLUE. While holding the FUNC
button;
 Press and hold Input Button 25 on the Aspen RCP-3232 or Input button 9 on the
RCP-1616.
 The Input Button will be BLUE.
 The TAKE button blinks RED.
 While continuing to hold the FUNC button and the input button, press the TAKE
button to execute. The RCP will be reset to Factory IP defaults.
Button Brightness
To set the front panel button brightness;
 Press and hold the FUNC button until it turns BLUE.
 Press and release the Salvo button while holding the FUNC button.
 Output buttons 1-8 will be green.
 One of the Input buttons 1 through 16 will be GREEN to indicate the current
brightness setting.
 Press Input buttons 1 through 16 to select the brightness setting. Output buttons
1-8 will change to indicate the brightness setting.