Sierra Video RCP-1616 - Manual (Page 41)

ASPEN 1616 AND 3232 RCP CONTROL PANELS
31
For example, if the IP address is 192.168.1.200
 Press and hold the FUNC button until it turns BLUE
 Press Output Button 26 on the Aspen RCP-3232 or Output Button 10 on the
Aspen
RCP-1616. This button will turn blue.
 Press OUTPUT 1 button.
• Input 1 will turn on briefly
• Input 9 will turn on briefly
• Input 2 will turn on briefly
 Press OUTPUT 2 button.
• Input 1 will turn on briefly
• Input 6 will turn on briefly
• Input 8 will turn on briefly
 Press OUTPUT 3 button.
• Input 10 will turn on briefly
• Input 10 will turn on briefly again
• Input 1 will turn on briefly
 Press OUTPUT 4 button.
• Input 2 will turn on briefly
• Input 10 will turn on briefly
• Input 10 will turn on briefly again
To change the IP address;
This only works if the operator is allowed to change the IP Address at the front panel (see
“Network” in the configuration section of this manual).
 Press and hold the FUNC button until it turns BLUE.
 Press Output Button 26 on the Aspen RCP-3232 or Output Button 10 on the Aspen
RCP-1616. This button will turn blue.
•
Output button 1 through 4 will turn GREEN if the IP Address can be changed
from the front panel. Otherwise, these buttons will be BLUE.
 Press OUTPUT 1 button. This button will now blink.
• Three of the INPUT buttons 1 - 10 (for 0) will turn on briefly to display the 1st
octet of the IP address.
• Press 3 of the INPUT buttons 1-10 (for 0) to set the IP address for this octet of
the IP address. The Take button will now blink.
• Note that leading zeros are required.
• The Input button will be GREEN while it is held down.
• Press Take to change the IP Address.
 Press OUTPUT button 2. Repeat the procedure above for the 2nd octet of the IP
address.
 Press OUTPUT button 3. Repeat the procedure above for the 3rd octet of the IP
address.
 Press OUTPUT button 4. Repeat the procedure above for the 4th octet of the IP
address.
 Release the FUNC button to exit.