Sierra Video RCP-1616 - Manual (Page 36)

SIERRA VIDEO
26
Source based Switching
1. Select an input
2. Select (enable level) to be switched by toggling the “A” and “V” button.
3. Select an output (. In auto take mode, the switch will occur immediately)
4. If auto take mode is not enabled the “Take” button will blink RED- press take to initiate
the switch, or you can select additional outputs to preset takes for multiple outputs to the
same selected source. In the latter case all selected outputs will be switched to the
selected source when take is pressed.
5. If an output is blinking, selecting it again will turn it off.
To do breakaways, see the section under Destination based switching.
Source based Status
When an input is selected, the output(s) currently connected to that input will light.
Selected input button will be GREEN.
Output button colors:
CYAN to indicate video and audio.
GREEN to indicate video only.
BLUE to indicate audio only.