Sierra Video RCP-1616 - Manual (Page 13)

SIERRA VIDEO
3
Installation
Introduction
Installation procedures are similar for all panels covered under this manual. Exceptions, if
any, have been noted in each of the following paragraphs.
Rack Mounting
Carefully inspect the frame to ensure that there has been no shipping damage. Make
sure all shipping material is removed from the RCP frame.
The control panels described in this manual can be rack mounted in a standard 19" (RU)
EIA rack assembly and includes rack "ears" at the ends of the front of the frames. It does
not require spacing above or below the unit for ventilation.
To rack mount any of the RCP panels, simply place the unit's rack ears against the rack
rails of the rack, and insert proper rack screws through each of the holes in the rack ears.
Always rack mount the panel prior to plugging the unit into a power receptacle or
attaching any cables.
CAUTION!
The operating temperature range of this product is 0 to 45ºC. Do not exceed the maximum (45ºC)
or minimum (0ºC) operating temperature.
If installed in a closed or multi-rack assembly, the operating ambient temperature of the rack
environment may be greater than the room ambient temperature. Therefore, consideration should
be given to installing the equipment in an environment compatible with the manufacturer’s
maximum rated ambient temperature.
Dimensions
Aspen RCP-3232 is 2 rack units high, 19” wide, and 1.25” deep.
Aspen RCP-1616 is 1 rack unit high, 19” wide, and 1.25” deep.
Chapter 2