Sierra Video RCP-1616 - Manual (Page 34)

SIERRA VIDEO
24
Switching the Routing switcher
V and A Buttons
V (Video levels) button will enable the video level(s) to switch.
A (Audio levels) button will enable the Audio level(s) to switch
In normal operation with at least one audio level configured:
• The V button will be on by default.
The A button will be on by default.
• The V and A buttons will toggle on/off when pressed.
In normal operation with no audio level configured
:
• The V button will remain on and will not respond to any selection of this button.
• The A button will remain off and will not respond to any selection of this button.
Destination based Switching
1. Select an output
2. Select (enable level) to be switched by toggling the “A” and “V” button.- see above
3. Select an input (In auto take mode, the switch will occur immediately.)
4. If auto take mode is not enabled the “Take” button will blink RED- press take to initiate
the switch.
Break-away Switching
When an audio layer is configured, it is possible to switch only video, only audio, or both.
To do that, toggle the V and A buttons so that only the desired level type is lit.
Example (with auto take disabled):
1. Press output 2
2. The input it is connected to will light. If audio and video are both connected to input 5, it will be cyan.
3. Press input 6. It will blink cyan. The Take button will blink red.
4. To switch only audio to source 6, turn off the V button. Input 6 will now blink blue.
5. Press the Take button.
6. Input 6 will now be solid blue and input 5 will be solid green.
Note: the V and A buttons can also be changed prior to choosing a preset.