Seaward KD1E User Manual
Page 6
KD1E Range
Operating Instructions
4
Never hold the instrument between the
hand guard / digital display housing and the
contact electrode.
Where applicable, the limit mark is a band, approx.
20mm in width, printed on the body of the detector and
extensions rods.
The Potential Indicator and all associated
cables and leads must be checked for signs
of damage before the equipment is operated.
Always ensure the earth cable is securely
attached to the equipment and that the clip is
connected to earth during tests.
Always ensure equipment is properly rated for
use at the voltage in the system under test.
The Potential Indicator must be proof tested
before and after use.
2.0 Safety
Notes
This KD1E Range of Potential Indicators has been built
and tested in accordance with:
BS EN 61243-2
The KD1E Range of Potential Indicators has left the
factory in a perfectly safe state. To maintain this state and
ensure safe operation of the unit, all notes and warnings
in these instructions must be observed at all times.
This instrument should only be used by competent,
suitably trained personnel, wearing appropriate PPE, after
due consideration of any hazard involved.
Never allow any part of the instrument below
the limit mark to make contact with a live high
voltage conductor.