Seaward KD1E - Manual (Page 14)

KD1E Range Operating Instructions
12
8.0 Optional Extension & Bent End Rods
8.1 Attachment
8.1.1 Loosen but do not fully remove the knurled head
on the extension rod.
8.1.2 If the equipment is fi tted with removable contact
electrodes, remove the domed head from the
digital unit or neon unit. Store the domed heads in
a safe location.
8.1.3 Attach the extension rod onto either the digital unit
or neon unit and ensure that the two elements are
fully mated without over tightening.
8.1.4 Tighten the knurled head at the end of the extension
rod to secure the two elements together.
At no time after the extension unit has been fully
tightened to either the digital unit or phasing rod
should any attempt be made to separate the two
elements until all testing (including proof testing)
has been completed.
8.1.5 To remove an extension rod from either the digital
unit or neon unit, loosen the knurled head at the
end of the extension rod before detaching the
extension rod from either the digital unit or the
phasing rod.
8.1.6 Replace the domed head on the digital unit and /
or neon unit and tighten the knurled head on the
extension rod when complete.