Seaward DO5000 Series - Manual (Page 32)

Operating Instructions Microhmmeter Type DO5000
27
6 Accessories
6.1 Leads
The DO5000 may be used with a variety of lead sets. The following are the available selection.
Remember, if you do not see suitable leads for your application, please consult our customer
help desk.
6.2 Wire Clamps
For the precise measurement of 1 meter cable samples we offer 2 wire clamp options.
6.3 Coin Jig
For the measurement of bi-metal coins to ensure the resistance of the two metals is within pre
defined limits.
6.4 Interfaces for the Remote Control of DO5000
Ordering Code Description
HS01-P Duplex Handspikes with 2.5 metre lead length, current and
potential spikes suitable for plate or Bussbar
measurements.
HS02-P Duplex Handspikes as a HS01-P but with 2.5 and 15 metre
lead lengths
LS03-P Large Kelvin clips with 3 metre lead length suitable for
attaching to rods bars or cables up to 38mm diameter
LS04-P As LS03-P but with lead lengths 3 and 15 metres
LS05 Executive lead set consisting of 4 x 1 metre leads with
banana plugs, 4 x crocodile clips 4 x test prods and 4 x
Kelvin clips (KC1) jaw opening 4mm
LS06-P Kelvin lead set comprising of miniature Kelvin clips (KC2)
with 1 meter leads attached terminated with banana plugs
Jaw opening 6mm. Suitable for fine wires.
Ordering Code Description
C02 1 metre wire clamp with metal base and provision for
temperature sensor suitable for wire cross section 1 to
100mm
2
C02a 1 metre wire clamp with metal base and provision for
temperature sensor suitable for wire cross section 0 to
1000mm
2
CO3 1 metre wire clamp with water bath for the precise
measurement of 1 meter cable samples 1 to 1000mm
Ordering Code Description
CJ01 COIN JIG will accept all bi-Metal Coins
DO5000-GPIB Talk/Listen IEEE-488 Interface
DO5000-PLC PLC Interface includes Analogue Output and Potential free
Contacts for Hi/Lo limits
Ordering Code Description