Seaward DO5000 Series - Manual (Page 18)

Operating Instructions Microhmmeter Type DO5000
13
3.6 About the Function keys
The top row of function keys are only used to select menu options. The lower row of function
keys is enabled only when entering values; these instances are covered later in this section.
Both rows of function keys are shown in figure 3.6.1
Figure 3.6.1 - Function keys
The [Quit] and [OK] menu options consistently use the [Quit] and [OK] keys. Use the [Quit] key
to leave a menu or return to the Resistance Measurement mode screen. Use the [OK] key to
confirm a particular choice and continue to the next set of menu options.
Not all function keys are used to access the Configuration Mode. Some just invoke the
function which is printed on the key. For example pressing [ZERO] immediately sets the
measured value displayed to zero.
The rest of this section describes each key in detail and gives examples of how to configure
the measurement to your requirements.
The last used set up conditions are stored when the instrument is turned off and restored
upon switch on.