Seaward DO5000 Interface - Manual (Page 36)

- 36 -
APPENDIX I
RS-232/IEEE-488 COMMAND SUMMARY
Single Wire Interface Messages (IEEE-488 Only)
DAV
Data Valid
NRFD Not Ready For Data
NDAC Not Data Accepted
REN Remote Enable
IFC Interface Clear
EOI End Or Identify
SRQ Service Request
ATN Attention
Multi Wire Interface Messages (ATN=Low) (IEEE-488 Only)
GTL
Go To Local
SDC Selective Device Clear
GET Group Execute Trigger
DCL Device Clear
SPE Serial Poll Enable
SPD Serial Poll Disable
MLA My Listen Address
UNL Unlisten
MTA My Talk Address
UNT Untalk
Programming Language
Both interfaces use the same commands.
For the RS-232 interface these commands are sent as part of a serial string.
For the IEEE-488 interface these commands are sent as a Multi-wire Interface
Message (with ATN=High).
Configuration Commands
SENSe:
FRESistance:RANGe <range>
FRESistance:RANGe?
FRESistance:MODE
FRESistance:MODE?
SOURce:CURRent <magnitude>,<current mode>
SOURce:CURRent?
Trigger and Measurement Commands
INITiate
*TRG
FETCh[:FRESistance|:TEMPerature|:TCOMpensate]?
INITiate:CONTinuous or <0|1>
INITiate:CONTinuous?
READ[:FRESistance|:TEMPerature|:TCOMpensate]?
ABORt