Support – Seaward Apollo 600 User Manual

Page 31

Power off the instrument.

Disconnect all test leads and accessories.

Position the instrument face down and remove the screw holding the battery compartment
cover in place.

Remove the battery compartment cover.

Remove the battery pack from the compartment and unplug the 4 way connector.

Connect the 4 way connector of the new battery to the 4 way header in the battery
compartment, put the battery pack into the compartment.

Relocate the battery compartment cover and fasten in position with the battery compartment
screw.

ONLY USE A REPLACEMENT BATTERY PACK THAT HAS BEEN SUPPLIED BY
SEAWARD OR A SEAWARD APPROVED DISTRIBUTOR.

19. Support

The Apollo 600 must be registered with Seaward before support will be made available.

For Technical Support contact:

Tel: (+44) 191 587 8718

For help or advice on Service and Calibration contact:

CalibrationHouse

Seaward Electronic

Bracken Hill

South West Industrial Estate

Peterlee

Co Durham SR8 2SW

England

Tel: (+44) 191 5878739

(+44) 191 5878737

Email: [email protected]

Calibration House is part of the Seaward Group.

19.1

your product here:-