Seaward Apollo 600 - Manual (Page 14)

You can use the Camera function to attach photos to the asset record.
This button will enable and disable the flash light.
Press this button to take the picture.
This button will attach the picture and go back to the record. To add another picture
press the ‘Camera’ button again.
This button will cancel the picture and allow you to take another.
11.1.2 Using the Risk Based Retest Period Calculator
The Risk Based Retest Period Calculator will allow you to select options using the
arrow keys from the dropdowns. It will then determine if the asset is Low or High risk
and advise retest periods for Formal Visual and Full Test.
This is the Accept function. This will accept the changes made in the current screen
and move to the next screen.
11.1.3 The Formal Visual Inspection
All preset test sequences start with a Visual Inspection.
Using the Camera in this screen will tag the picture to the test result.
This is the Pass Icon.
This is the Fail icon.
This means that the inspection is not applicable to the EUT.
Pass
All
Pressing the Pass All button will apply a pass to all relevant inspections and move
onto the next test.
11.1.4 The Electrical Tests
The Apollo 600 has probe detection that will automatically flag up if you do not have the
correct probe configuration for the test you are trying to perform.
During the tests you can see the test duration, limit and result on screen, see 9.1 Screen
Layout.
Should any test with the sequence fail the sequence will be aborted and you will presented
with the Notes screen by default but this can be changed, see 11.5 PAT Settings.
11.1.5 Printing a Label
If you have a TnT Bluetooth printer configured with the Apollo 600 you can set it to
automatically print a label after each test.